Mipro ACT-80HC Rechargeable Wideband Digital Handheld Tr Bedienungsanleitung

User GuideACT-80HC Rechargeable Digital Handheld TransmitterWideband All rights reserved. Do not copy or forward without prior approvals MIPRO.Spec

1415Y E S N OAF LIMIT AF LIMITAF LIMIT: Setup and Change of Input Limita. Press MODE and stop on the AF LIMIT function; the display showing the curr

1617RF -HIRF POWERRF -LO WRF POWERRF POWER: RF Power Selectiona. Press MODE button for selection of RF POWER. Selection of RF-HI or RF-LOW can be se

1819Battery Status100% 80% 60% 40% 20% 10%Indicates the power remaining in the transmitter battery. When the battery has less than 10% power remaining

! Turn the power switch to ON position where transmitter will be activated and LCD will lit up.! Turn the power switch to OFF position to shut down th

2223Setting MUTEMUTE button! Press MUTE button to enter mute status. At mute status, AF indicators will become “AF MUTE” and blink continuously. All t

24254. Furthermore, a large-diaphragm directional microphone has a very distinct proximity effect. When the microphone is close to the mouth, the bass

WARNING1. FOR OUTDOOR USE:To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.2. UNDER WET LOCATION:Apparat

011 Controls and Indicators3 Operating Instructions for Insertion & Removing Battery5 Patented Protection Cover Display ScreenHow to Setup Transm

18500 rechargeable lithium battery23 Capsule Module: Protects detachable microphone capsule module and internal foam prevents breathing, wind and POP

Protection cover's patented design protects accidental access to power switch and its rugged material and snug fit offer protection to both power

 LCD Screen Parameters Screen AF (audio) MUTE Transmitter Battery Meter LCD Display Screen16Fully Lit LCD Display67! When power is off, reverse-in

N OENCRY PTIONY E SAF LIMITMANUALMUTE MODE486.500MHzFREQUENC Y0 dBAF GAINLOW CUTAF LOW- CUTRF-LOWRF POWERGroup and ChannelFrequency Sensitivity Le

1011**NOTE:When programming a special frequency via monitoring software, the LCD screen cannot display the number. This is because this special channe

1213**NOTE:1. The higher the gains are set, the lower the dynamic range for signal input and the greater the danger of unwanted noises and feedback ge